Iron - Multiviewer. Description dorabotochki allowing to measure the speed of programs to curb without climbing in the codes - an easy push of a button.

<b>Iron</b> - Multiviewer. Description dorabotochki allowing to measure the speed of programs to curb without climbing in the codes - an easy push of a button.


         MULTIVIEWER.

music by DNK
(C) SParkerXLD
_______________________________


  "Laziness - the propeller of progress"

                   (C) of folk wisdom.


  If someone read a page ZF # 3 of counting strokes on the 
curb, I can offer primbamas small, allowing no

inserting OUT'y, to do the same thing. As
that this thing can do, explain
later, after we collect our Multiviewer ...


  To build, we need:

 - Soldering

  - Hands, who can keep the soldering iron
 - Screwdriver
 - Scalpel or knife
 - Outline your kompa
 - 2-3 meters of wire (MGTF)
 - 2 Diode KD522B (you can do without
them, but then during the switch can
be failures)
 - 2 resistor of 10-15 ohms each (if
No diodes, resistors are not needed ...)
 - Power switch with three buttons
(Mozhmo removed from the radio)
 - 2 liters of alcohol and cucumber ...


  Then you can plug into a network payalnok
(Plug), unleash housing company (not over
head), to find the microchip and track
going to her 9 foot:


  Kay: D35 (TM9)
Scorpion: D35 (TM9)
Pentagon: D43 (TM8)


  after having found a path to take
hands of a scalpel, and cut it. We
obtained two ends: first approach to
chip and connects to the plug, we point
2 (see map), and second, that connects to point 1. Next, take 
the hands of the PA yalnik and collect our shemku ... 

wrFE

  1 o

                  o

          Normal

                  o to 9 feet
+5 R1 o o 2
o

                        R1, R2-10-15kOm
RD VD1 VD1, VD2-KD522B
o> o

                  o Signals:
/ DataBus RD - 21 foot Z-80

                  o wr7FFD:
2 +5 R2 o KAY-256: D45 (TM9) 9 foot
= O Scorpion ZS-256T: D46 (TM9) 9 foot
8 Scorpion ZS-256: D48 (TM9) 9 foot
9wr7FFD VD2 Pentagon: D62 (TM9) 9 foot
o> o

                  o

          # 7FFD

                  o



  If everything is completed, and the inclusion was
successfully, you can try out the functions of gadgets ... In 
Multiviewe'ra three stages are: 

 Normal - displays the contents on the curb
port # FE
 # 7FFD - On the border displays the contents of
Port # 7FFD
 # DataBus - on the curb displays the contents of the data bus 
while reading it, and in the last two modes bits 0-2

displayed on the curb, bit 3 - on Tape Out,
bit 4 on Sound, bits 5,6,7 are not running ...


  For coders the most important mode DataBus, unnecessarily if 
the program is synchronized to HALT or "hanging" on the 
interruption, then where the processor waits for a signal INT,

see shaded place where the same work
program, see "Multicolor" ... Very
effectively looks Basic-48 at Pentagon'e ... Also, this mode is 
quite helps in the repair of PCs, and setting it up ... 
Volatile data bus immediately becomes visible ...



  Now you can easily condemn the remaining alcohol, sometimes 
eating cucumber and see everything you have, in the presence of 
demos ... where the second more violent than the first ...

_______________________________