╔════════════════════════ ═══════════════════ ═══════════════════╗ ║ What if it comes in handy? ║ ╙─────────────────────────────── ───────────────────────────────╜ (C) EVP-SOFT, Vika Greetings, dear readers... This txt is a manual for wrist electronics digital watches, watches in the form of a pager, and in general - this is almost a standard. So, there are usually three control buttons - “MODE”, “AL.TM”, “DATE”, if Of course, don’t count the backlight button. The "MODE" button switches operating modes, there are four in total: normal, stopwatch, setting the alarm, setting the clock. The switching is cyclic, but after making changes to any mode, the "MODE" button immediately exits to normal small mode. In normal mode, the "AL.TM" button allows you to view the time The name for which the alarm is set. If you press it without releasing it also "MODE", then you can turn on/off the mode, where every full hour The systems will emit a short signal; if the mode is turned on, then immediately When you press "AL.TM" on the display, all seven days of the week are turned on. If together with"AL.TM" press "DATE" this will lead to on/off alarm clock, if it is turned on, then the display shows the corresponding welcoming icon. The "DATE" button in normal mode allows you to find out the number and even such valuable information as the month number. ;-) Now let's look at the stopwatch mode. Auto stopwatch mode nomen - i.e. you can run it and go to the clock. Starts and stops the stopwatch with the "DATE" key. "AL.TM" key resets the counter, but if you press it during counting, it will records the readings on the display, but the counting will not be interrupted, and pressing it again, you will see a continuation. First 30 minutes format on display will be "minutes:seconds.1/1OOcek", and then, after 30 minutes it will become "hours:minutes.seconds". The alarm setting mode is very simple - the "AL.TM" button switches hours or minutes for editing, and the "DATE" button increases the selected parameter by one. The process can be accelerated rit if you press and hold "DATE". Now it’s time to set the time. There's a button here "AL.TM" switches parameters for editing: seconds, minutes you, hours, date, month and day of the week. Well, the "DATE" button is produced leads to changes, and seconds can only be rounded to a minute up or down. And when setting the clock, you can select start counting cycle - 12 or24, switching is done by "rewind" the clock by 24 hours. If there is an "H" in the seconds place this means that mode is set to 24, if it is “A” (“AM”) then this is the period from 0 to 12, and “P” (“PM”) - from 12 to 24.
Share your thoughts about the article