======================================================== FREE FIGHT!=====
[CATV]
Today we will tell you about cable TV. who doesn't know
(?) - this is when you don’t need to connect an antenna to the TV a
all harotobo you company on a similar cable
will pass it on. and not just those programs that are on the air,
but there are also several others, usually bourgeois,
useless (a la bbc, eurosport, fashion-tv, etc...) and
all this with hi-qual images!
harotobo company accepts all this and sums it up
cables to our houses, in every house there is an amplifier,
the signal in the cable goes out... the amplifier is constantly eating
energy, the company pays for it, of course.
with an antenna you will never get this, no matter how hard you puff!
(but doesn’t eat anything).
so don't puff and don'trun with her on the roof (in vain)
currently the trouble is that the services of these companies are
paid, for us - about 110 rubles per month.
sorry 110 rubles!
I have a guest here in the studio, right now he’s everything to you
will tell...
hello, my name is Mr. x! well, why?
start... anyway, if you want to use it for free
catv, then listen here, everything will happen right now. from the amp output
there are thick 300-ohm cables, about two cm in
diameter, in short, you can immediately distinguish them from normal ones, on
each entrance has one such cable.
it contains a powerful signal, many, many decibels.
depending on the house, they can be placed in the entrance
either top to bottom (like mine) or bottom to top (almost in
all nine-story buildings), then the amplifier is in the basement of the house.
well, the distribution cable is connected to this cable
box and place it in the shield, usually next to
collective antenna box.
the shield is not the same, the katopom has elekktro brushes, and
another, be careful not to mix it up, cnekmahob is so little!
this is such a big antenna, placed on the house, big
so rusty, well, I’ve probably seen it, and maybe to it
Any connection to the clavicle, will there be a lot of current from it?
what's the point? I doubt something. and often they are finally broken
stand (and sometimes lie). and sometimes they finally go somewhere
devayuzza. I didn't take it.
or rather forget about them. well, the catv box has like
usually four exits (for four apartments) and
power signal input-output (cable from output to
next floor and connect to the next one
box).
there are different boxes, bourgeois and ours. different
design, dimensions and connectors, and bourgeois ones also
shine! (like my quartz at 14.3mhz)
beautiful!
in our city our boxes are square, they close
lid, crepizza it (lid) on two buhtukas, a
Often it’s not there anymore, it’s lost! lives inside the box
a board with several coils and reels on it. cable in it
crepizza by pinching ita pair of screws, one
clamps the screen and the second - the central wire.
well, you can’t connect to the main signal,
it would suck to show you, he’s too wet, and
connect to the outputs (of which there are usually four). well
what could be easier - take it and screw your cable there
and you're done!
currently you will be disconnected from there at the first check. and
They will probably cut your cable at the root, for example straight
at your door. so you don't connect anymore. and
they will call you at your apartment. to sign something.
let them into the apartment and especially not sign anything
nada, otherwise they will be fined. so tell me you're still small
and my parents are not at home right now. then they will cut the cable and
will go into oblivion. Amen.
so this is a method for complete suckers. but you are not like that!the most convenient way is to connect to the wire of those who
already connected. now you have to do it indirectly
(in parallel), ptm-that if the clavicle is connected like this, then it will be
show bad both for you and for them. they will call the guys and
they will find everything and ring your doorbell again.
break off.
a happens so that the signal is protected under load
75 ohms (this is the resistance of the TV antenna input). a
When you connect one output to two antenna inputs, then
This signal is already loaded at 75/2 = 37.5 ohms! that's why
the image begins to appear for both you and them.
how can I wash this? it's simple - there are cheap ones
devices cost from ten to twenty rubles,
they call it a splitter for x (x) TV, they have one
entrance and several exits, most often two. they
We are engaged in matching the resistance of antenna inputs,
In short, you can connect several TVs toalone
cable, and everyone will show ok!
I don’t know what’s inside, but they do their job.
better buy a bourgeois one with connectors for them
as a rule they write “X-way splitter”, it’s very convenient
connect, otherwise solder in the panel, and even at night somehow
uncomfortable. These connectors seem to be called f-connector,
They cost two rubles in total. you strip the cable under it and
you just screw it on him. there is a thread inside and it
It is well fixed on the cable.
when he is dressed, the central core sticks out of him
cable, and at the end it has a movable piece with a thread,
freely cool, and all this can be connected to
to the corresponding socket. it has a hole in the middle and
there is a thread around it, you just screw the plug to it and
that's it!
well, buy the most compact one like thisdivisor, three
plug these into the cable and wait until the night. or (better) -
early morning (about four o'clock), PM - why should you turn it off?
for the time of those you connect to. a if they
watching TV, then when they lose everything, then
someone might come out and wonder if that’s all you
ruined it.
you.
in general, inspect the shield, and specifically, look where it goes
the wire to which you are going to connect. if he
immediately climbs out of the shield and stretches along the wall, then
there is nowhere to hide your divisor and this method will not
will give you a ride. look at the rest, most likely, at least
there will be one like this.
and now you have found a wire that is stretched inside the wall,
through special holes for the cable, hurray! now pull
for it carefully, the more it is pulled out, the
better. now cut it off right at the hole and carefullyclean up. don’t fuss, but don’t dig around, everything is ok! clean up
now the other end of it and crush it on both ends
f-plug, and to your cable (which goes to your home
goes) put it on too.
now connect the signal source to the divider input, a
the other two, obviously, go to the exits and try to put them in
this is all as deep as possible into the hole in the wall, push
something, if you can’t push it deeper with your hand, although
usually this is enough.
a if the cable is pulled too tight (if it is not
pull even a little bit out of the wall), then find a piece
cable is a little longer than the one that now comes from
pacnp. boxes to the entrance of your divider, centimeters per
twenty, and connect it instead of the old one. and calmly
push it into the wall.
well, it’s like: [don’t stretch it out here - then we’ll extend it here
here!]
Well, that's all, now you can watch catv until
will turn them off. as a rule, this does not happen for years.
your neighbors share cable TV with you!
you can share this signal in your apartment for as long as
any time (if you have several TVs) similar
splitters. I’m connected to two TVs, that’s it
ok...
what to do if there is a suitable one on your floor,
Is there no cable running through the wall? you can look at
the floor below - above, there will definitely be something there! do it on this
floor is the same, but the cable is from the second output, which
should go to you, reach your floor through these same
holes. now they are often already busy with some thread
other wires (telephone, radio, antenna
collective), so it’s just not nponuxytb...
then find three meters of hard thick wire and
nponuxhu him in the holeslowly, because it’s tough, then
She should get through without any difficulty.
this is what fitters do simply when doing something, I
saw it a couple of times. then tie it to the end of this wire
thinner wire, pull it out, and then connect the cable to it and
pull it out for her.
you can do this at any time, nothing suspicious in
there’s no such thing, so don’t sleep until four in the morning
optional. nponuxhu cable during the day, and the rest at night
finish it. by the way, cable, which you will nponuxubatb with
floor to floor you will need about 2.5 - 3 meters
In general, it’s better to take a regular, black thread, and not
white, bourgeois, so as not to be conspicuous.
this method with a divider is the most realistic, because when checking
I check the boxes themselves to see if there are any extra ones.
connected subscribers and are searched (first of all)
all sorts of wiring screwed to them.
wiring, any, no matter how they are twisted, will be
everyone has been found, so don’t think it will work, it will
no use.
here is another method, but it has disadvantages and is complicated
implementation: at night in some entrance you find
unnecessary catv junction box, disconnect from
all the wires are on it and you take it home, take it apart (get it out)
everything from the inside). ours is easy to disassemble - everything is there
screws, but the bourgeois one is more complicated - their bodies are shiny,
do it with a wire sticking out of the back wall of the box,
I don’t think there’s any need to explain. just solder it on,
Obviously, no one is going to free allotment, no one is going to katopomy
connected, see in advance which one is not busy.
and if there are no free ones, then this method will not work.
a, and you won’t get anything if the box of crepes is straight
on the wall - there will be no space left for the dedicated wire, yes
and you will see him crawling out from under the box. ahere
if the box is attached to the iron strips inside
shield, then - just right, there’s still room left in the back...
there are a couple more ways, but they will not give full
qualities, or, in case of failure, threaten with unpleasant
consequences, so there is no need to talk about them.
(although this one, with drilling a hole, can also fail, and
what will happen...)
by the way, the cable that will go to your home can
to be absolutely anyone, most importantly, obviously, antenna, the most
you can buy a thin one, five rubles per meter, for
the quality of the image does not reflect this in any way, everything will be
ok!
well, that's all, guys, dividers and screwdrivers in your hands and
forward! Mr. x was with you!!! (not trash)!
Share your thoughts about the article