╔════════════════════════ ═══════════════════ ═══════════════════╗ ║ About everything in the world. ║ ╙─────────────────────────────── ───────────────────────────────╜ (C) EVP-SOFT Hello everyone! Material on identifying counterfeit audio cassettes in this number simply did not have time, so I will give two useful diagrams - ki. Switch illumination. This connection diagram is │ ends in parallel KDS22B ┌─────────────────────┐ │ switch cycles, and, ┌───┴───┐ │ │ when it is turned off the light is │ / ─│─ └──────│ The LED lights up, indicating that ─┴─ │ ─┴─ │ │ helps in the dark */ │ /* │ ALZO7BM,GM,DM,... └ quickly find the switch- ─┬─ │ ─┬─ │ / tel. If the lamp is over- │ ─│─ / / was on, then the LED └───┬───┘ 150 kOhm, 0.5 W │ does not light up. This circuit- │ ┌───────┐ ┌─────│ The example can also be used: thread for illumination └───────┘ │ call buttons. Emergency lighting. Ifyour chandelier is intended for only one ┌───────│ lamps, you can reduce the brightness. Usta- ─┴─ │ new this diode will reduce the voltage by half, /* D245A │ and also, if you first turn on standby mode - ─┬─ │ then this will extend the life of the lamp (since the lamps └ └ usually burn out due to an inrush current when turned on - / / nii while the coil is cold). If you have collected // backlight, then pay attention to the polarity of the di- └───────│ ode regarding the upper diagram. │ Both of the above schemes were assembled by me and work normally.
Share your thoughts about the article