Metallurgy - Turba on Quorum.

╔═-------------------------------------═╗ 
|            Metallurgy...  ║ 
╚═------------------------------------------------═╗╔╗║ 
 Sokol/Infotek  ╚╝║║ 
  ╚╝ 
  Turba on Quorum.             
             
 I salute you!  Izv.  for this delay 
articles. Well, in general, to the point.                
   In general, the turbo consists of installation 
several conductors (preferably MGTF) and 
cutting multiple tracks (required 
fine surgical intervention in 
the life of your computer, because need to re- 
cut the road under two, in the form of a 'bu- 
terbroda', mikrukhami).                    
   The essence of this turbo is to accelerate the pro- 
processor during memory regeneration, because 
in quorums, memory regeneration is performed - 
Xia Uloi (quorum subspecies).          
   Here are the instructions for turbocharging:      
                                          
      1. Make sure you have Quorum        
     2.Look - not 128is he...       
          3.Turn on the soldering iron.            
    4.Remember whether you know how to solder.     
   5. YOU CAN NOW POWER THE COMPUTER   
                DISABLE                 
 6. Disassemble (within reasonable limits) the computer.  
       7.Find the processor in it.         
  8.Find the 28th leg of the processor with the signal 
                  ____                    
                  RFSH                    
                                          
    9. Assemble the following circuit:     
                                          
                                   +5V    
                                    |     
____ LN1 LI1 |     
RFSH 5+-+6 13+--+ #     
----_-++ +---------+& |11 LE1(D14)#     
    ^ |+-+ 12|  +--+ 2+--+1 | CLK 
here |    RAS ---+ |  +---+1 +---+--   
jumper|          1O+--+ +---+ |         
      +------------+& +--+ 3+--+         
                  9|  |8                  
           CAS ---+ |                   
                   +--+                   
                                          
  The RAS signal is taken from the 3rd leg of TM2, 
which is in the second row from the left, and the 6th 
below.  And the CAS signal must be taken from the 6th 
legs of the same mikruha.                      
  LN1 should be looked for in the 3rd row on the left, 5th 
below.  Those roads that go to legs 5 and 6 
necessarycut, turn over the board and re- 
cut the road connecting legs 5 and 4: 
then connect the 4th leg with the trim, which 
previously I went to the 5th leg (otherwise it wouldn’t work 
will be).                                   
  LI1 is either a new mikruha or an os- 
the remaining part of the 'temporary V1.O'.           
  LE1 is the 2nd row, 5th from the bottom.         
                                          
  Well, that's all, but this turbo is turbocharged 
the computer is somewhere around 1O-15 percent and is threatening 
glitches (which are far from noticeable 
immediately) on computers that have 4 me- 
GHz processor.                     
                                          
       For this please excuse me