============================================================pC>>ZX=====
everyone was probably holding a fucking mother board in their hands. and
probably everyone saw all sorts of jumpers jumping on it,
mukpocxemok, panels for them, connectors...
what is there that a spektrumist needs?
[this is generally about boards from xt/286/386 by the way]
Well, first of all, of course the panels. for 16 contacts,
20,24,28,40... panels for mikruhi in planar cases
we don't need it. throw it away.
secondly, this is TTL mikruhi. they (the bourgeoisie) have them
They call 74 episodes mikrukhs. maybe the ones you need
pick it out and put it in the Spectrum.
thirdly, these pins are so golden that
put on jumpers. they can find many uses.there are also 62-pin connectors, but they have a pitch
2.5Hmm, and not 2.5, like ours, so for example in
The system connector of the scorpion cannot be soldered.
but you can put it on the peripheral connector. I have him dressed
for a long time. I just liked that he dressed softly and
black. ours are all blue! but nothing good came of it -
dressing him rather rudely, and other side
effects during operation appear due to the fact that the area
contact of each contact of the connector with the contact
The recipient's fee is very small.
disk drive for example kada factory - image in this
the moment twitches slightly...
shit turned out to be short.
there are almost always shiny quartzes at 14.31818Mhz,
it doesn't work for metrmshobeta, aceditor and more
something freezes. fpl works great with it, by the way.
but it shines.
and does not fade.
well, blocking capacitors are often beautiful,
you can just unsolder them.
how to pick out panels: take the board to the kitchen, turn it on
stove (if it is gas, of course), put the board on top and
heat for about 30-60 seconds, then quickly
you pick out the desired panel and it is free from the board
it's enough. Don’t touch it with your hands - it’s hot, better yet
The board has not cooled down, pick out the rest.
If necessary, repeat heating until you remove everything. I'm for
one heating took out about four panels on average. a
you can simply turn the heated board upside down with the panels
and tap on it (not with your finger, of course) - maybe something
fuck off. They just laid down something, some kind of newspaper,
Otherwise there will still be solder in balls.
By the way, you can collect it too. also connectors
I pick them out so you can remove them directly with your hands,
quickly or else you'll burn your uncut fingers for a year
claws.
If anything, it’s not my fault.
Microhairs can also be removed in the same way, here you go
there is a high probability that they will have time to throw away
such overheating of the hoof, but it depends on your luck. quickly
If you take it off, maybe everything will turn out fine.
you can’t unsolder the microcircuit with a soldering iron, there’s no other way out
no...
By the way, carry out heating work in a ventilated
indoors, otherwise this varnish burns on the board
the smell is not bad, the smell is persistent, it evaporates
slowly, so nothing in the eveningIt's better not to do this.
took and picked everything! Well done!
a board on which there is nothing interesting left anymore
torture, carefully place it in the trash can. there is a current
the kind that don't fit into the bucket. put it next to it.
Share your thoughts about the article