DonNews #20 26 февраля 2004

Железо

Hard - Skroler for kempston mouse interface to Create Soft.

__________________________________________



          HARD



(C) Bit_XXL
__________________________________________


   Health for all is re-Bit. Today I will ship you, Speckman, of
NetScroll'e on SPECCY. At this time I will tell as of Kulnev, 
beautiful and original pieces of iron type KEMPSTON MOUSE 
INTERFACE by CREATE SOFT make curly from MGTFa and tortured 
burnt rosin, while making her realize the mice with a wheel. 
The entire procedure takes about 20 minutes (for those who are 
afraid of picking hot damn in devayse, bought for good money 
and has already become a rarity, too and be, you can not read 
and do, allow:). 

   So, for the commission of the evolution in the mouse
economy (do not forget to determine whether
Economy in freshly mouse:) need two mikruhi and a liter of 
wires. Mikruhi These - and 1533AP6 561IE11 or relevant 
zabugornye analogues (AP6 on motherboards of 386/486 can even 
vykolupat 1531 series, ie SN74F245, and IE11 on the PC you are

hardly find, so go look for somewhere a digital PBX and 
withstood there. It will be called CD4516 or MC14516. This 
right now, was the advice for residents of the Far North :).


   The same should hold another preparatory event (no, not 
rolled forward vol40 °, we need a sober mind!). The point

that we need a signal RESET,
mind you, not inverted, as the procedure or
hoof A20 slot. Make it possible without
hanging ext. inverters, but several
izvraschenskim way - in KP11'y that
formerly in charge of a button, but now we do not
useful. To do this we must first find it on the board, although 
you can not find because I'll tell you where it is: in the 
upper left corner, if the plateau is situated buildings to 
themselves and a slot down. Now, because we will it maliciously 
juzat for their own purposes, we must eliminate its impact on 
data bus, ie cut off the legs 4,7 and 9 (a 12 So I will not 
connected, since in CREATE SOFT times there was no 4-Button

mice:) or vypayat them from the board. Too
have to do with 1 and 15 feet. Then
served on 1'yu foot signal from the hoof slots
at No. A20, 15'yu to throw the land, and
on 14'yu and 13'yu +5 or ground, respectively.
As a result of this perverted to 12'y leg
obtain this same RESET. Do not like the method? Then go asked 
around on what to Desert boiled corn! (Quote right now

was on Uncle WILD'u). What, in your town do not have a desert? 
Then fine, just Take the signal from somewhere else, such as a 
modem, as a Klimycha done. 

   After all this ugliness to figure out where prisobachit 
another counter 561IE11. At Klimovskaya devayse I did soldered 
to the other IE'shku, the one in the upper right corner. Solder 
should be only 4 feet: 5, 8,9,16 and the remaining otginaem in 
hand. 3,4,7,12 and 13 feet IE'shki us vaasche not useful, they 
can even break off (just look, do not split casing mikruhi, and 
then she would be offended!).


   On the first leg must submit reset,
which we have suffered at the foot of 4'y KP'shki.
At 10'yu and 15'yu transmits signals from the wheel Bat. Now 
came the turn of AP6'y pomuchatsya. It is necessary because it 
anywhere stick. I wonder, chtoli, about her writing? Here and 
stick it ... chewing gum to a TV set, the button POWER! Cool? 
Only the improper use of nonrenewable resources is k. .. oops, 
i'm sorry, in my mind under the guise of advertising made it to 
the election murk ... So on what I mean? Well, yes, we take 
AP'shku, and solder to her diet (10 - gnd, 20 - +5), without 
forgetting to also submit five and the first of its hoof. This 
AP'shka we will have 'face port # FADF 'myhi, tobish will throw 
in this port state loaves and net-skrolika. A

therefore be entitled to her brain, or rather
force included only on the port.
It is simple: to 19'yu her leg sends a signal to 11'y feet 
556RT11 (there still rezyuk bus 5 solder). Now she will request 
to throw push-button port on the data bus, all you need to live

together, namely: down 4.2 button down
9.6 roller. Leg 5 is necessary for stability
submit to +5. (And if it is necessary that a specific 
prikonkretnaya stability, it is possible and at +12 ... smoke a 
stabilnyyprestabilny mourning ...:) If you do not do, then bit 
3 port can be anything anything (mikruhe as she pleases 0 or 1;

or maybe 2 if you filed a 12:), and the Bat
will be determined in the prog only
when she wants. But it might not
want! So what better to do.

   The final part of epics. On foot
11.18 AP6'y serve the data bus D0 ... D7, respectively. It 
contacts the following slots: A6, A7, A8, A11, A12, A10, A9, 
A3. Although it is possible and left without attention KP11'e 
soldered: the top of them (those farther from slot) leg 4, 7, 
9, 12 - is D0 ... D3, while the the lower the same leg - D4 ... 
D7. At 9.6 feet APshki throw outs 6,11,14,2 counter (not

forgot to solder? And then nothing this Moodna read, and 
'screen radiation danger for your health!!! ':). Button of 
stay. Average boldly apply solder to the 4 th leg APshki (it's 
up to how do you put their hands disbanded, was on

10'y leg KP11, over which we first
fun to mock). But with the remaining
buttons up to you: who left Knop hanging on a bit (just like 
CREATE SOFT), while the one bit to 0. I have made in corporate, 
that is left - bit 1 (3'ya leg AP6) and the right - bit 0 (2nd 
leg). If not can decide how these fucking

Button still solder - can kot through a double switch, only if 
you will have to pull it every time the layout fire / cancel do 
not like ... Can it (switch) directly to cram myshu (Sometimes 
at the bottom is the switch, but Wheeled mice hardly happens 
...), will cool ... probably. The left button is taken from

6'y foot corner KP11, and right - with 3'y.


              HISTORICAL!


   You won NetScroll Kempston
Mouse Interfase! By the way, I forgot to say:
you wasted it all done - you have because the mouse
so no! Or is there? Read last
number? If you have not read, do not hurry to tear everything 
up and restore, but found there schema modifications and 
zabatsay Bat and prisobach to his tail at 11 lived. Built-in 
trailer there, what will come up. And if you count that will 
fit 15'tikontaktny type COM'ovskogo, then here's a pinout it 
became the standard for one reason only: integer Two such mouse 
I had already done myself beloved and KLIM'u, both checked and 
set up on his self-made interface (in the style of hi-tec on 
cardboard cut from boxes of chocolates, and soldered to the 
percent still the same-MGTF'om).



   1 - GND ground

   2 - MB middle button

   3 - RB Right Button

   4 - LB Left Button

   8 - Vcc +5 V

   9 - Xb 15 foot IE11 port # FBDF

   10 - Xa 10 foot IE11 port # FBDF

   11 - Ya 15 foot IE11 port # FFDF

   1912 - Yb 10 foot IE11 port # FFDF

   1913 - Ra 15 foot IE11 port # FADF

   14 - Rb 10 foot IE11 port # FADF

   5,6,7,15 - not connected.


   At this my ravings over. If you have any questions about Opus
or any other, you can zamylivat
them to this the address: bit-xxl@yandex.ru.
However, you can zamylit and if
issues will not arise, it is not forbidden. You can also 
contact the Editor Don News'a, particularly to someone Clim.


-----------------------------------------
  P.S. This whole crap is written in November 2003 after 
reading a 10-room FullPull row (I think, much ...). To this 
day, both mouse furychat, the truth of Climate flew for unclear 
reasons AP6 Port # FADF. I have the same problems nebylo.



   P.P.S. Offer my apologies lamerskie
for the program from 'TestMouse' from the application
last issue: onaya not boast at least its dvuhekrannostyu, as 
well as idiotic exit to somewhere. She simply throws out the 
7-th bank, if it does not start zeros, which is found in 
particular and start this of the newspaper.