Lprint #05 06 июня 1997

Железо

Iron - Connect the second drive.

 Iron connect a second drive ;-) 08



 WW: So it's not such a stupid question, and if people
ask how to do it / in my time, I also did not know.
Since I just recently pull up his Drive: B, then the memory
tell / While "Iron" - not my element.
 Most Chapter B / R, it must be powerful / Baytovski - the two 
are not pull /, well, everything else is easier as dirt:



                 <- Built to Drive: A



                  <- This was

                    That's right ->



                 * Built-in Drive: B->



           The wire going to the controller TR-DOS

 * It is used exactly the same connector as the stands Drive: A,
open it and see a lot of "needles" on which to impale veins
wire, just below the first, as shown in the diagram / if not
know how to open the socket Drive: A /, the main thing - it is 
not "Fluff" / all should be parallel to Drive: A /. Exactly the 
same is the case with the connector on food, soldered wire on 
connector Food drive: A and solder them to the second connector 
to the same contacts / mix hard, just three wires. Now

paste them to a place / old connector still drive
: A new, appropriately: At. Now jumpers, drives can
be different, but all of them has "pins" which are
next / they are usually 8 (4 for two), but there are more (in 
Bulgarian with I have them 10). Look where standing on your 
first drive jumper / she is always on the edge / and exactly 
the same place on the second drive, but not the second kantakt:


        Drive: A Drive: B
          ■ ■ ■ ■
          ■ ■ ■ ■
          ■ ■> ■ ■
          ■ ■ <■ ■

               Jumpers / can be a piece of foil /

 That's all problemmy.Samoe complicated - it is right nakalot 
veins the jack / I got the first time, Ars - witness.

 I hope I have described all popular.